Installing a ceiling rose or decorative medallion is an inexpensive manner to feature a dramatic impact to your room. Installing it with the aid of your self is a fairly easy procedure so here is a walk via of a way to pass approximately it.
Pre-Installation
Firstly, take essential safety precautions by way of turning off the primary power to save you electrocution and use a tester to make certain that it is off. Clean your ceiling before you start to keep away from any debris or dirt getting within the manner; the usage of a few mild cleaning soap with a sponge will do quality.
Next, you have to reduce the middle hole in the medallion if it does not already have one. If the medallion does have a hole, test to peer if it allows the light fixture get admission to to the wiring and extend the hole if it does not. For reference on how large you need to cut the hole, region the cover plate on the medallion and draw strains round it. After drawing the lines, use a compass and draw a circle 1/2 an inch in the reference lines.
Drill a hollow within the medallion then use a drywall saw to cut alongside the circle. Make sure to reduce cautiously and use a few sandpaper to easy out any difficult edges and uneven contours. Before bringing out the adhesive, take a look at the assembly. Place the medallion so that the center allows get admission to to the electric box. If the hollow isn’t always huge sufficient to get entry to all wires, you could expand it the use of sandpaper. Test to see if the length of the threaded bolt permits it to attach the fixture to the junction field whilst the medallion is connected. After this, you could paint your medallion to match your partitions and then start the set up.
Installation
Hold it by means of its face and use a caulk gun to apply the adhesive on the returned of the medallion. Attach the medallion in area through positioning the center over the junction container. Make positive to screw the duvet plate to the threaded bolt earlier than the adhesive dries and tighten it so it could fasten the medallion into location.
Use a drill to force screws beyond the medallion and inside the ceiling in order that the medallion is fixed. Make sure to screw them in hidden places to avoid tarnishing the advent. Remove the cover plate and fill any gaps between the ceiling and medallion the use of caulk. Remove the threaded bolt and the mounting bar then use nuts on the mounting bar to fasten it to the threaded bolt. Pass your fixture’s wires through the threaded bolt and out of the mounting bar then screw it to the fixture.
Get someone to assist via keeping the fixture at the same time as you join the mounting bar and junction box. Connect the wire from the junction container to the screw in the mounting bar. Twist the stop of that cord with the ground cord from the fixture and use a twine nut to cozy it. Secure the fixture’s impartial twine with the ceiling’s white wire using a cord nut after twisting them together. Connect the last wire to the black twine from the ceiling then replace the quilt plate by attaching it to the medallion. Turn the power returned on and recognize the consequences.